Joined
·
1,154 Posts
That's what spray paint is for. The feathers look great.
-
February's IndianMotorcycles.net Photo Challenge Is Now Open For Entries!
Thunder Works "Black Feathers"
We are introducing a new product. These are Black Feathers made from 1/4" thick ABS plastic. They come with double stick tape. They can be applied to most any surface on your bike. (They don't work well on the tires.) They can enhance the "Indian" look of your bike. (Not recommended for Harleys.) They are being offered at a special intro price at www.IndianAftermarket.com
![Feather Leaf Quill Plant Wing]()
![Motor vehicle Headlamp Vehicle Automotive lighting Automotive design]()
![Light Automotive lighting Headlamp Vehicle Helmet]()
1 - 4 of 4 Posts
Joined
·
1,154 Posts
I have a bison skull printing on my son's 3-d printer at this moment. Going to be doing some design tests.
Someone can break out a dremel on the feathers - grind down the middle on both sides of the spine. Round the feather from the spine to the outside edges. Grind most of the thickness off the outside edges. You can even grind in some light grooves to give the feather some hairs. Spray the whole thing in a satin white and then spay the edges in satin black. You could make the whole thing look like a 3-d eagle feather. The overall thickness, IMHO, is fine for longevity.
Someone can break out a dremel on the feathers - grind down the middle on both sides of the spine. Round the feather from the spine to the outside edges. Grind most of the thickness off the outside edges. You can even grind in some light grooves to give the feather some hairs. Spray the whole thing in a satin white and then spay the edges in satin black. You could make the whole thing look like a 3-d eagle feather. The overall thickness, IMHO, is fine for longevity.
Joined
·
1,154 Posts
Gold, copper or silver leafing on the feathers would look good. Especially those with the gold leaf done on the tank badge already.
Joined
·
1,154 Posts
As I said a few days ago. Playing with 3d printer. Just did the logo below this evening. Still learning the software and the printer.
1 - 4 of 4 Posts
