Indian Motorcycle Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
324 Posts
2015-16 service manual says Remove radiator cover fasteners. Slide radiator cover down to disengage upper radiator mounts. Remove the coolant return hose from the oil cooler assembly to drain the coolant. Pressure test before and after servicing cooling system. Reconnect coolant return hose to oil cooler assembly.Install radiator cover. Remove seat and fuel tank. Remove cooling system pressure cap. Use pinch pliers to pinch off coolant line between coolant reservoir and thermostat housing. Install a cooling system vacuum bleeder on the pressure cap opening to create a vacuum in the cooling system. Using vacuum bleeder draw in coolant to fill the system. Remove vacuum bleeder and install pressure cap. Remove pinch pliers, Add coolant until reservoir is 1/2 full. Install gas tank. Run engine until cooling fan cycles on and off. Recheck coolant level in reservoir and add to the full cold mark. Repeat fill/bleed procedure until coolant level in reservoir remains at full cold level.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top