Indian Motorcycle Forum banner
5K views 6 replies 5 participants last post by  djcutnpaste 
#1 ·
I'm attempting to install Rizoma Club S lights. I'm following this article

Long-Term Indian Scout: Rear Fender Modification

I need help with wiring up factory lights to those lights. I don't think I need a module. I believe I can make them work with relays. What do you guys think?

I have 6 wires coming from bike, that I spliced. And my LED (Rizoma) only has 4
The rizoma lights has the 3 functions

-running light (low red)
-brake light (bright red)
-signal indicator (bright orange)

Tire Automotive tire Wire Rim Spoke

Electrical wiring Wire Electrical network Electronics Cable
 
See less See more
2
#2 ·
I'm attempting to install Rizoma Club S lights. I'm following this article

Long-Term Indian Scout: Rear Fender Modification

I need help with wiring up factory lights to those lights. I don't think I need a module. I believe I can make them work with relays. What do you guys think?

I have 6 wires coming from bike, that I spliced. And my LED (Rizoma) only has 4
The rizoma lights has the 3 functions

-running light (low red)
-brake light (bright red)
-signal indicator (bright orange)

View attachment 381824
View attachment 381826
Thats how i chopped my rear fender.
 
#7 ·
I've only done the aftermarket LED's on the Bobber, the scout is different as the turn signals are separate from the brake light. I would suggest checking for negative sources. On the US bobber the Brake/Turn signal is actually a negative pulse so a relay is needed to convert it to positive for aftermarket lights to work. easy enough to check with a test light.
 
You have insufficient privileges to reply here.
Top