Search Results for ‘wiring’

hello, I am building a new rear fender for my 2016 scout, my goal is to create custom turn signals and break lights to work with the new design. I have some yellow and red outdoor 12 volt led strips laying around that I intend to use. I am gonna go out on a limb and assume that this is not going...

Purchased a trunk second hand that had the wrong wiring harness for my Chieftan Classic so I have no use for it. Looked around online and this price seems reasonable, just trying to offset what it'll cost to get the right one. I'll cover standard shipping to lower 48 US. Int'l potentially...

Hey folks, cannot get my Rivco air horn to work more than 2-3 seconds without throwing a code (DTC520293, FMI6/5). I need some advice please. I found an older thread about using a relay with a diode and I purchased one and it still throws the code after 2-3 sec but the compressor does not come...

How many of us have removed their rear fender on our Scouts to do a little work, and cut the plastic Tie strap, thinking that you could easily just strap down your harness wires when you put everything back together??? Guess what? Not that easy!! I have yet to find replacement options to...

I am adding a cell phone holder/charger. I need to run the cable to the battery. I have a 17 roadmaster . Any suggestions on how to run the wire so I don’t have to worry about it melting on the engine?

Asking for the community's assistance in locating pictures or information regarding the handlebar controls wiring. I'm looking to identify the wiring connectors that plug/attach from the handlebar to the bike harness (18' Bobber w/ABS). There are 3 in total. The left side has one 10 pin male...

I struggled for a good heading to put on this question, but my issue is that I've added the Custom Dynamics brake light flasher module and it along with my trailer light connectors fills up any space I had under my seat. Then with the Roadmaster seat power wire for the heat and the...

Has anyone changed the tail lights on your 2019 bobber? Clearly they are wired different than the 18. I have joker machine dual rat eye tails and got an intensifier to run both lights at the same time as the driving, blinker, and brake light but it uses ground signal for the blinker and not...

I plan to install a 2-channel 300 watt amp in my saddlebag with matching wattage saddlebag speakers. There is a 16-pin connector under the seat used for the factory Indian saddlebag speaker and amp kit. I need to find out which of the wires in this connector are the left and right audio from...

Went down to my garage for the 2nd ride of the season this morning but when I punched the button the starter hardly groaned. It wouldn't turn over at all. But, the whole dash lit up just fine. I punched the button again and this time I got a loud pop - not like a backfire pop but like an...

Currently trying to build chopper with 2016 chief motor. Purchased frame then motor without harness or carb. My question is : what do I need to simplify the wiring to just make it run? I can buy a harness but prefer to make my own with few wires. . Thanks Wes

Sorry need to remove the post

Here is my question, I purchased a Roadmaster trunk and have fitted it to my Vintage. Now what I need to figure out is how to hook up the brake light and to get the power amp to work along with the power lock button. I have seen some trunks hooked up just wondering if anyone has done this or...

I would like to install my RAM cell phone mount and GPS on my 2017 Roadmaster handlebar. I've never opened the fairing before. Before I go mucking around blindly, can anyone point to a resource showing how and where to access 12v, for wiring accessories?

Looking for the best way/place to tie in my Garmin Zumo GPS power cabling. Maybe the music and other features as well, but that is just a bonus, if you did it... I have my mount on the right handlebar close to the fairing. I have yet to dive into my fairing, so any Pictures and Instructions are...

I am putting on an XP-W60 brake light strobe adapter. black and red wires in and out. Took the seat off my 15 Road Master and holey cats which red and black do I install to? bought on Ebay.

Just bought a Scout Sixty yesterday after riding Honda's for 35 years. Would like to put a war bonnet, sold by Indian Charlotte, on my new bike. Need help on how to wire it? How to secure it under the fender and from there how and where to wire it into the bike? Thanks a million!

I was preparing a nice video for everyone on how to change fork oil, and I opened up the nacelle on the vintage. I had been warned about the 4 zip ties attached to the nacelle backing plate, but not about how short the wires were for the auxilliary light switch. Well, I pulled it right out of...

This thread is designed for people who want to post anything they've done themselves working on their Indians. Questions, Concerns, and Help from other members is the goal here. Anything from how you put speakers on to changing out your exhaust or oil. take pictures, videos, anything to help out...