Search Results for ‘transmission’

Out on my 16 Scout yesterday running her pretty hard, ran it up close to the rev limiter and hammered second and punched it and something ( assuming tranny ) went bang. It still moves in 1-3 ( haven’t tried 4-6) but it’s making a TON of noise and vibration. Curious if anybody has any ideas? My...

I have a 2014 Indian chief vintage with 35000 miles. A couple of days ago, my bike started experiencing an intermittent problem, which usually happens after the bike has been ridden and warmed up for a while (sometimes the problem exists, other times it does not). Specifically, when I start...

I am working on a 2003 roadmaster Gilroy When heavy and light occasionally accelerating the bike will jutter/slip and it makes a clanking noise. the customer has spent a lot of money on this bike already here's the list of new parts motor rebuilt by Gilroy rebuilder down south, baker...

It appears that my 'bouncing' off a pot hole whilst accelerating and simultaneously up-shifting from 3rd to 4th caused enough damage that my transmission (w/ ~4900 miles) will no longer hold its main shaft seal in place. I don't know if I bent the main shaft, or the 5th gear, or the deal is...

Ok occasionally my 60 will start in third, instead of 1st. Yes I put the bike into 1st before stopping. So from a dead stop the bike will cycle from 1st, 2nd, then settle into 3rd and have a rough lugging roll to get to speed in 3rd. anyone having this issue? Only other gearing issue is...

So, long story short I had some clutch issues and the clutch burned out entirely. Glazed the plates pretty damn well at 4,500 miles ;) After arguments with polaris about a warranty claim, which was denied, I had my local dealer service the bike and replace the clutch on my dime. So, to the...